
Technical Parameters:
Working temperature |
-20-60°C |
Supply voltage |
DC12~24V |
Current |
<60mA |
External dimension |
L122xW71×H24mm |
Packing size |
L137*W80*H55mm |
Net weight |
180g |
Gross weight |
270g |
Effects model |
133 |
Maximum control points |
1024 (Low-speed) points, 2048 (High-speed) points |
Controlled IC Model |
Such as the TM16726,TM2801,TM8806,WS2811, UCS1903 etc. (specify the required model on orders) |
External Dimension:
(Controller) (remote control)
Interface Specifications:
Power input:Adopt DC plug seat connector Load output:Adopt the 10 units of plug seat with screw
Synchronization interface:
Adopt standard network line interface
controller and Remote function:
Direction for use:
1.Connect the load well wire at first, following by the power wire; Please ensure short circuit can not
occur between connecting wire before you turn on the power. Then set the steps as follows.
2. Press the "On / off" button to take the controller off before setting the menu.
3. Press the “up”, “down” button one time at the time, and LED would be bright at this moment. Then
press the "Mode / Speed" button to get into the menu settings screen.
4.The first setting screen is for “High-speed, low speed settings”, and the LED would display "SHI" or
"SLO". Then press the “up” and “down” button to select the mode. (If the IC on the light bar is high-speed mode, you should choose “S-HI”, and choose “SHI” when lowspeed.) The factory default
is for the high-speed mode.
5.Continue to press the "Mode / Speed" button to enter the second screen-“Control points setting”.
The LED display 4 digit is for the number of control points. To plus or minus the number by pressing
the“up” and “down” button (Long pressing can adjust quickly). The factory default is for 50.
6.After setting well, press the "On / off" button to save and exit.
7.There are 4 buttons in total on the control panel, function of each button as below:
On/off:It can open or close output.
Mode/Speed :Mode adjustment / speed adjustment function switch (The first LED displays H for model adjustment, shows S for the speed adjustment.)
UP:Mode+/Speed+ button. When in mode regulator function, it is for “Mode+”. When in speed regulator function, it is for “Speed+”.
DOWN:Mode-/Speed- button. When in mode regulator function, it is for “Mode-”. When in speed regulator function, it is for “Speed-”.
A: Mode adjustment / speed adjustment function switch (The first LED displays H for model adjustment, shows S for the speed adjustment.)
B:Mode+/Speed+ button. When in mode regulator function, it is for “Mode+”. When in speed regulator function, it is for “Speed+”.
C:Mode-/Speed- button. When in mode regulator function, it is for “Mode-”. When in speed regulator function, it is for “Speed-”.
D:On/Off button: It can open or close output.
Note: After powering, the red light would bright. And each press, the green light flash one time.
Interface Specifications:
Typical Applications:
Application Circuit1:
Application Circuit2:Multi-motor synchronization function application:
( a.Cascade Connection,the master controller just output the signal to the first branch controller, and the next branch controller signal is from the previous branch controller,etc)
Prev product:No prev product Next product:magic control |